Led Indicators; Nb3711 Interfaces - NetModule NB3711 Software Benutzerhandbuch

NB3711
NRSW-Benutzerhandbuch - Version 4.6.0.100
Nr. Label
11 MOB 4 / WLAN 1
12 MOB 3 / WLAN 2
13 Extension
GNSS
14

3.4.2. LED Indicators

Status LEDs
The following table describes the NB3711 status indicators.
Bez. Farbe
STAT
[1]
MOB1
[1]
MOB2
[1]
WLAN1
[1]
WLAN2
GNSS
VOICE
DO1
Function
TNC female connectors for MIMO WLAN antenna 1
TNC female connectors for MIMO WLAN antenna 2
Galvanically isolated extension port M12 connector
TNC female connector for GPS/GLONASS antenna
Tabelle 3.2.: NB3711 Interfaces
Status Funktion
blinking The device is busy due to startup, software or configuration up-
date.
on The device is ready. The captions of the top bank apply.
on The device is ready. The captions of the bottom bank apply.
on Mobile connection 1 is up.
blinking Mobile connection 1 is being established.
off Mobile connection 1 is down.
on Mobile connection 2 is up.
blinking Mobile connection 2 is being established.
off Mobile connection 2 is down.
on WLAN connection 1 is up.
blinking WLAN connection 1 is being established.
off WLAN connection 1 is down.
on WLAN connection 2 is up.
blinking WLAN connection 2 is being established.
off WLAN conne ction 2 is down.
on GNSS is turned on and a valid NMEA stream is available.
blinking GNSS is searching for satellites.
off GNSS is turned off or no valid NMEA stream is available.
on A voice call is currently active.
off No voice call is active.
on Normally open output port 1 is closed.
off Normally open output port 1 is open.
20