Tool Specifications; For Your Safety; Operating Controls - Bosch GUF 4-22 A Handbuch

Euro • BA 3 609 929 301 • GUF 4-22 A • OSW 11/00 • GB

Tool Specifications

All-Purpose Saw
Order number
Rated power input
Power output
No-load speed
Cutting disc dia.
Cutting disc hole dia.
Corner distance
Shadow gap width
Groove depth
Groove width
Weight (without accessories)
Protection class

Operating controls

1 Motor
2 Parallel guide
3 Cutting mark
4 Chip ejector
5 Knurled screw
6 Cutting depth scale
7 Course cutting depth adjustment
8 Scale
9 Wing nut
10 Angle guide
11 Screw
12 Lug
13 Adhesive rail
14 Auxiliary handle
15 Spindle lock button
16 Clamping lever
17 Handle
18 Allen key
19 On/Off switch
20 Thread for auxiliary handle
21 Adjusting screw
22 Adjusting dial
23 Allen screw
24 Wing nut
25 Drive spindle
26 Distance bush
27 Cutting disk
28 Clamping flange
29 Cover
Not all of the accessories illustrated or described are
included as standard delivery.
GB
GUF 4-22 A
0 601 607 103
620 W
320 W
10 000 RPM
105 mm
20 mm
80 mm
12.5 mm min.
22 mm
2.8/4 mm
2.4 kg
/ II
Before each use of the machine, check the
cable and plug. If damage is detected, do not
use the machine. Have repairs performed only
by a qualified technician. Never open the ma-
chine yourself.
Before any work on the machine itself, pull the
mains plug.
The machine should be operated only with the
accessory devices and the auxiliary handle.
Always direct the cable to the rear away from
the machine.
Apply the machine to the workpiece only when
switched on.
Take care to advance uniformly (decreases
the danger of accidents and lengthens the ser-
vice life of the cutting disc and the machine).
Do not brake the cutting disc to a stop after
switching off by applying pressure to the side.
Use only sharp and flawless cutting discs.
Replace cracked or bent cutting discs immedi-
ately!
For safety reasons, only the cutting discs list-
ed in the operating instructions may be used.
Protect the cutting disc from shock and im-
pact!

For your safety

Working safely with this ma-
chine is possible only when the
operating and safety information
are read completely and the in-
structions contained therein are
strictly followed. In addition, the
general safety instructions in the
enclosed booklet must be fol-
lowed. Before using for the first
time, ask for a practical demon-
stration.
If the cable is damaged or cut
through while working, do not touch
the cable but immediately pull the
mains plug. Never use the machine
with a damaged cable.
Dust that is produced while working
is detrimental to health. Use dust
vacuuming.
Wear hearing protection.
Wear safety glasses.
11