Lionelo Tulia Bedienungsanleitung Seite 8

7-2. You can see the red indicated line,now the mesh is free to set the width
you need.
7-3. Pull the gate out.
7-4. Insert the lower bar of handle into lower locking hook E.
7-5. Push the handle upper part into upper locking hook D.
7-6. Push down the width memorized button I to fix the mesh width. Now the
mesh width is memorized.
8. To open the gate (fig. 8)
No need to push or pull the "button I", just follow below steps when open the
gate every time:
8-1. Push down the released buttons J on handle both side.
8-2. Take out the gate handle from upper and lower locking hooks.
8-3. The mesh will retract automatically.
Reset the mesh width:
The exclusive "memory" design allows to walk through the gate conveniently.
Every time pull the gate out,it will be at the same width.
If need to install this gate at a new place,please follow step 7-1~7-6 to set up
the mesh width. Please make sure the red indicated line is invisible after step 7-6.
CARE:
1.
Wipe surface by a damp cloth or sponge with mild detergent and warm
water. Never clean with abrasive,ammonia based, bleach based or spirit
type cleaners.
2.
Any additional and replacement parts should only be obtained from
manufacturer.
The product has been tested and meets all the requirements of the:
The pictures in this manual are for illustrative purposes only. Therefore, they may differ
EN
EN 1930:2011
from the actual product.
‑ 8 ‑