Electrolux GA60GLICSP Benutzerinformation Seite 12

12 www.electrolux.com
the next programme. This activity
increases the total water consumption of
a programme by additional 4 litres and
the total energy consumption of a
programme by additional 2 Wh. The
rinsing of the softener ends with a
complete drain.
Each performed softener rinse (possible
more than one in the same cycle) may
prolong the programme duration by
another 5 minutes when it occurs at any
point at the beginning or in the middle of
a programme.
All the consumption values
mentioned in this section are
determined in accordance
with the currently applicable
standard in laboratory
conditions with water
hardness 2.5mmol/L
according to the 2019/2022
regulation (water softener:
level 3).
The pressure and the
temperature of water as well
as the variations of the
mains supply can change
the values.
How to set the water softener
level
Make sure the appliance is in user mode.
1. Press
• The indicators
• The indicator
• The display shows the current
setting: e.g.
2. Press
setting.
3. Press on/off to confirm the setting.
6.3 The rinse aid empty
notification
The rinse aid helps to dry the dishes
without streaks and stains. It is
automatically released during the hot
rinse phase.
.
,
are off.
still flashes.
= level 5.
repeatedly to change the
When the rinse aid chamber is empty,
the rinse aid indicator is turned on
notifying to refill rinse aid. If the drying
results are satisfactory while using multi-
tablets only, it is possible to deactivate
the notification for refilling rinse aid.
However, for best drying performance,
always use rinse aid.
If standard detergent or multi-tablets
without rinse aid are used, activate the
notification to keep the rinse aid refill
indicator active.
How to deactivate the rinse aid
empty notification
Make sure the appliance is in user mode.
1. Press
• The indicators
are off.
• The indicator
flashes.
• The display shows the current
setting.
–
–
2. Press
3. Press on/off to confirm the setting.
6.4 The rinse aid level
It is possible to set the released quantity
and
of rinse aid between level 1 (minimum
quantity) and level 6 (maximum quantity).
Level 0 deactivates the rinse aid
dispenser and no rinse aid is released.
Factory setting: level 4.
How to set the rinse aid level
Make sure the appliance is in user mode.
1. Press
• The indicators
and
• The indicator
• The display shows the current
setting: e.g.
.
,
still
= the rinse aid empty
notification is deactivated.
= the rinse aid empty
notification is activated.
to change the setting.
.
,
are off.
still flashes.
= level 4.
and