Vcom Admin Utility - Exsys Ex-6121Poe Anleitung

English EX-6121PoE

6. VCOM Admin Utility

Since the EX-6121PoE was shipped with DHCP mode enabled, an IP address is required to con-
figure it. By default, the EX-6121PoE automatically receives an IP address from a DHCP server
(e.g. your router). If it is not connected to a DHCP server, use the default IP address: 192.168.2.1.
To determine the IP address, you must install the VCOM Admin Utility (vspsetup.exe) that comes
with the device. The installation program is located on the driver CD included in the scope of deliv-
ery in the following folder.
Attention! Please run the installation program with right click "Run as administrator!
1. Get the IP address: Start the VCOM Admin Utility (right-click on the VCOM Admin Utility
shortcut on the Windows desktop and start this with „Run as Administrator").
Click Remote Device Management > ADD Device > Search
After the EX-6121PoE was found, click Cancel to abort the search. Click OK, to add the EX-
6121PoE.
© Copyright 2021 by EXSYS Vertriebs GmbH. All Rights Reserved
20