WIKA Cryo Gauge 712.15.100 Betriebsanleitung Seite 21

4. Commissioning, operation
Dismounting cable socket
The cable socket is prefitted and must be dismantled as described below.

Screw

Cable cover cap

Cable cover

Socket insert

Cable socket baseplate

Sealings

Fully loosen the screws on the cable cover cap with a slotted screwdriver (0.6 x 3.5 mm)
■
and remove them.
Pull the cable cover, along with the socket insert, out from the cable socket baseplate
■
(joined permanently with the instrument).
Take the cable cover cap and push the socket insert out, downwards, completely through
■
the cable cap.
Pin assignment cable socket
4 ... 20 mA, 2-wire
Do not use this
terminal
U +/I+
B
Supply
voltage
+0V/GND
Evaluation
Terminals 3 and 4: For internal use only
(display)
Terminals 5 and 6: Reset zero point
Differential pressure gauge models 712.15.100, 732.15.100, optional for hazardous areas



Only use cable with a diameter of
7 ... 13 mm



EN
21