Electrical Safety; Using An Extension Cable - DeWalt DCS331 Handbuch

DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
• This product is not intended for use by persons
(including children) suffering from diminished
physical, sensory or mental abilities; lack of
experience, knowledge or skills unless they are
supervised by a person responsible for their
safety. Children should never be left alone with
this product.

Electrical Safety

The electric motor has been designed for one
voltage only. Always check that the battery pack
voltage corresponds to the voltage on the rating
plate. Also make sure that the voltage of your
charger corresponds to that of your mains.
Your D WALT charger is double insulated
E
in accordance with EN 60335; therefore
no earth wire is required.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organisation.
E
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 3 A.

Using an Extension Cable

An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger
(see Technical Data). The minimum conductor size
is 1 mm 2 ; the maximum length is 30 m.
When using a cable reel, always unwind the cable
completely.
ASSEMBLY AND ADJUSTMENT
WARNING: To reduce the risk of
serious personal injury, depress the
trigger lock button and disconnect
battery pack before making any
adjustments or removing/installing
attachments or accessories. An
accidental start-up can cause injury.
WARNING: Use only D
packs and chargers.
Inserting and Removing the
Battery Pack from the Tool (fi g. 4)
NOTE: For best results, make sure your battery
pack is fully charged. The light will shut off without
warning when the battery is fully discharged.
TO INSTALL THE BATTERY PACK INTO THE TOOL HANDLE
1. Align the battery pack (b) with the rails inside the
tool's handle (fig. 4).
2. Slide it into the handle until the battery pack is
firmly seated in the tool and ensure that it does
not disengage.
TO REMOVE THE BATTERY PACK FROM THE TOOL
1. Press the battery release button (a) and firmly
pull the battery pack out of the tool handle.
2. Insert battery pack into the charger as
described in the charger section of this manual.
Blade Installation and Removal
(fi g. 6)
TO INSTALL A BLADE
NOTE: This jig saw uses only T-shank jig saw
blades.
NOTE: The DT2074 flush cutting blade is for use
with D WALT DCS331, DCS332, DW331 and
E
DC330 jig saws only.
NOTE: When installing flush cutting blades
(DT2074), the anti-splinter insert must be removed
and the shoe must to be in the 0° positive stop
position.
1. Lift the keyless blade release lever (e) as shown
in figure 6.
2. Insert the T-shank blade into the clamp
mechanism (k) while guiding the back of the
blade into the groove of the guide rollers (l).
3. The T-shank should be completely inside the
clamp mechanism as shown in Figure 6.
4. Release the keyless blade release lever.
TO REMOVE A BLADE
CAUTION: Do not touch used blades,
they may be hot. Personal injury may
result.
1. Lift the keyless blade release lever (e).
2. With a slight shake the blade will drop out.
EN GL IS H
WALT battery
E
41