Cavist CAVIST149 Gebrauchsanweisung Seite 11

Installing your wine cooler:
•These wine coolers are designed for free-standing installation, good ventilation is required
around the appliance, in order to dissipate the heat properly and to guarantee efficient cooling at
lower consumption. Sufficient clearance must be created for this purpose:
Gap to the back of appliance about 5cm and the side walls each about 10cm.
-
Clearance to the front must be created so that the appliance door can open without being
-
impeded.
• Position it in a place with sufficient strength to support its weight when loaded. To ensure that it
is level, adjust the height of the feet underneath.
•To get the best from your appliance with the lowest energy consumption, do not place the
appliance close to a heat source (heater, cooker, etc.), do not expose it to direct sunlight, and do
not place it in room which is too cold.
•Connect the appliance to a single socket, Be careful to support it, so that your wine cooler is
perfectly leveled. This will prevent any movement due to instability, generating noise and
vibration, and will ensure that the door seals perfectly.
Built-in installation for model diagram:
Operating your appliance:
Please use the appliance in a room with an ambient temperature between 16 and +38°C in order
to achieve better performance. If the ambient temperature is higher or lower, the performance of
your appliance may be affected and it may not be possible to reach designed temperature.