Optional Accessories - Makita DJS800 Betriebsanleitung

Hook
CAUTION:
Never hook the tool at high loca-
tion or on potentially unstable surface.
► Fig.9: 1. Groove 2. Hook 3. Screw
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
Blade rotation
The edges of the side blades can be used in four ways
by rotating the side blades as shown in the figure.
The time and procedure to rotate the side blades is as
follows:
• When inside edges of each side blades become
rounded to about half the width, swap each side
blades.
• When both edge of each side blades become
rounded, turn each side blades inside out.
► Fig.10
OPERATION
Lubrication
NOTICE:
Use the standard machine oil for steel
or the mineral spirits for aluminum.
Before operation, always lubricate the following areas:
A The both sides of the center blade which contacts
to the side blade L and side blade R.
► Fig.11
Adjusting cutting head angle
CAUTION:
Make sure the cutting head is
secured in the position after adjusting the cutting
head angle. Otherwise the cutting head may rotate
during operation and cause serious injury.
Rotate the cutting head while pushing the rotation
button.
Release the rotation button when the cutting head is in
the desired angle.
► Fig.12: 1. Rotation button
Cutting operation
CAUTION:
Wear gloves. Edges and chips of the
workpiece are sharp and may cause injury.
Secure the workpiece firmly. Move the tool forward
keeping the side blades flush with the workpiece
surface.
► Fig.13: 1. Side blade 2. Workpiece
MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
OPTIONAL
ACCESSORIES
CAUTION:
These accessories or attachments
are recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment
for its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
• Hex wrench (5/32")
• Makita genuine battery and charger
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
8 ENGLISH