Safety Instructions; Startup - AL-KO SPV 10000 INOX Betriebsanleitung

Safety instructions

about 15 - 20 minutes, the pump will automatically
switch on.
SAFETY INSTRUCTIONS
CAUTION!
The submersible pump may only be con-
nect-ed to an electrical device which
is compliant with DIN/VDE 0100, Parts
737, 738 and 702. Make sure that fuse
protection in the form of a 10 A automa-
tic cutout and a fault current guard circuit
with a nominal fault current of 10/30 mA
is installed.
CAUTION!
The supply voltage and current specified
on the type plate must be identical with
the voltage and current of your electrical
system.
CAUTION!
If you need to connect your pump to an
extension cord, make sure that the ca-
ble is 3 x 1.5 mm2 that it corresponds
to type H07RN-F and is compliant with
DIN 57282/57245. The connector must
be splash-proof. Cable drums must be
completely unwound.
CAUTION!
Do not attempt to make any changes or
modifications to the submersible pump
by yourself. You may endanger your life
or invalidate the warranty.
CAUTION!
Do not operate the submersible pump if
it is damaged.
CAUTION!
Never use the electric cable to lift, carry
or attach the submersible pump to ano-
ther object. Do not pull on the cable when
unplugging the pump.
CAUTION!
Make sure that the plug does not get wet.
477 215_b
CAUTION!
The submersible pump may not be used
for any other than its designated use.
Before putting the pump into operation,
make sure that:
the submersible pump, the electric
cable and the plug are not worn or
damaged and
Nobody is near, touching or in the
liquid to be pumped.

STARTUP

CAUTION!
You can cut off the tip of the multi-size
nipple to fit the diameter of the hose you
are using. Using a hose with the largest
possible diameter will greatly improve
the performance of the pump.
CAUTION!
Make sure that any electrical connec-
tions are not exposed to water and do not
lie within the outflow of the pump.
CAUTION!
When placing the pump in the liquid,
make sure to let it down slowly. You may
need to tilt the pump slightly so that air
trapped in the body is released. Set the
pump on the bottom so that it cannot
fall over. If the bottom should be sandy
or muddy or rocky and uneven, place
the pump on a suitable hard, flat surface
or suspend it from a rope attached to a
secure object. Make sure to leave ade-
quate room between the pump and the
bottom so that it cannot suck up solid
matter.
CAUTION!
Make sure that the pump does not suck
in solid matter. Sand or other abrasive
particles suspended in the liquid will lead
to increased wear and tear and may im-
pact the performance of your pump. Be-
fore lowering the pump into a well or
a cistern, attach a rope to the handle.
When placing the pump inside a cistern,
make sure that the shaft is large enough
for the pump to fit. For min. shaft dimen-
sions, see Figure C.
11