Prior To Commissioning - diversey TASKI swingo 755B Economy Bedienungsanleitung

Open battery compartment for maintenance
• The machine must be switched off.
Warning:
Before opening the battery compartment make sure
that both tank areas are empty.
• Disconnect the battery from the machine at the battery dis-
connection socket.
• Lower the suction nozzle.
• At the bottom left and right on the
front side of the machine you will find
the battery compartment release.
• Unscrew both screws and remove
them.
Variant: Machine with wet battery set
• At the bottom left on the front side of
the machine you will find the battery
compartment release.
• Press the release (e.g. with a screw-
driver) into the intended opening and
lift the tank until it locks.
• Tank position before change of posi-
tion.
• Stand behind the machine.
• Carefully open the battery compart-
ment until the driving handle is on the
ground.
• Carefully open the battery compart-
ment until the driving handle is on the
ground.
Warning:
After maintenance, carefully tilt the tank back to its
initial position and lock it.
Notice:
Lift the suction nozzle again
Notice:
Connect the battery with the machine at the battery
disconnection socket.
64

Prior to commissioning

Relocation drive
• Switch the machine on (main switch
button with 755B and key switch with
855B).
The display lights up briefly.
The battery level indicator notifies
you that the machine is ready for op-
eration. (In case of malfunctions,
please see page 70).
• By gently pushing the switch bracket
drive into the direction of movement,
the machine is set into motion. If you
let go of the driving switch, the ma-
chine will stop.
Brush installation
Before inserting, please check:
• that the brush does not fall below the red marking (bristles)
or 1cm of bristle length.
• the pad for wear and cleanliness before use.
Caution:
Do not use brushes which have reached their wear
limit. The wear limit is indicated by the length of the
red bristle. Do not use worn or contaminated pads.
Use original TASKI brushes only.
Failure to observe these instructions may result in inad-
equate cleaning results or even floor damage.
• Position the tools under the tool unit.
• Switch the machine on.
The indicator elements lights up briefly.
• Unlock the foot pedal and lower the
tool slowly.
While lowering the brush drive will
slowly start to pulse. In this way the
tool is centered and engaged.
The brush drive display lights up
Notice:
When the brush is down, gently moving the ma-
chine back and forth can make the clutch easier to
engage.