Kinderkraft JUNIOR FIX Bedienungsanleitung Seite 26

4.3 Installing/removing the booster seat base and backrest
Place the backrest flat behind the base and turn the backrest in the joint as far as possible to
connect it with the base. Position the backrest vertically.
Danger! When you adjust the backrest, make sure that that there is nothing near the joint.
Removal: bring the backrest in the joint to a vertical position and disconnect both parts of the
booster seat.
5. Installing in the vehicle
In the event of hard braking or an accident, people not strapped in with seatbelts may injure
other passengers.
Always make sure that:
• the vehicle's backrests are locked in place (i.e. that the lock of the folding back seat is in
place).
• all heavy and sharp objects are secured (e.g. on the rear ledge).
• all passengers are strapped in with seatbelts.
• the booster seat is always secured, even when it is empty.
Securing the vehicle
In certain vehicles, the seat fabric may be made of frail materials, which the booster seat may
ruin. You can avoid this by placing a blanket or towel under the booster seat.
5.1 Installing the booster seat for children in weight groups ll/lll with the safety belt.
IMPORTANT: You will find the locations of ISOFIX and top tether points and other important
information concerning installation of the booster seat in your vehicle in the vehicle's
instruction manual. You MUST read the manual.
• Adjust the headrest appropriately to the child's height (see point 4.1).
• Place the booster seat on the car seat. Make sure that the booster seat backrest is flat
against the car seat backrest (see point 4.2).
• Slide the shoulder strap through the red guide (D) under the headrest.
• Place the child in the booster seat and run the car seatbelt in front of the child. Lock the car
seatbelt to hear a characteristic "click".
• The hip strap should run under the armrest through the hip strap guides. The shoulder strap
should run above the armrest.
Attention! The shoulder strap should not be placed on the red point under the armrest.
Tighten the car seatbelt by pulling first the hip strap segment and then the shoulder strap
segment. Make sure that the hip strap stretches possibly low above the child's hips, fits in the
guides, and is locked with the buckle. The shoulder strap should run between the child's
shoulder and neck. Make sure that the strap is not too tight on the child's neck.
Recommendation! You can change the headrest height when the booster seat is installed in
the vehicle.
5.2 Installing the booster seat for children in weight groups ll/lll with the safety belt and
additional tethers.
• Press the ISOFIX release button (I) and slide out the ISOFIX tethers (H) as far as possible.
26