Adjusting - Kinderkraft SPINSTEP Bedienungsanleitung

● Be careful when riding bicycles, you should know how to ride to avoid falls or collisions that could cause injury to the user
or a third person.
● The safest areas for the persons using the bicycle are those with little or no vehicular traffic, such as private areas,
playgrounds, schoolyards, and school playgrounds.
● Maximum user weight − 25 kg
● Keep the packaging or dispose of it in accordance with local regulations.
● For the safety of children, do not leave parts of the packaging freely accessible (plastic bags, cardboard boxes, etc.). Risk
of suffocation!
I The main parts:
Part number
1 Frame
2 Rear wheels
3 Front wheel
4 Front fork
5 Bumper
6 Front fork fixing screws
7 Handlebars fixing screw
8 Handlebars
9 Mounting spanner
10 Bell
11 Basket
12 Basket fixing screw
II Installation of the tricycle:
Slide the rear wheels (2) in the frame (1) until you hear a click (Fig. A). Attach the mudguard (5) to the frame (1) using a screw
(21). Put the front wheel (3) in the fork (4) and tighten the front fork fixing screws (6) (Fig. B). Place the front basket ( 22) on
the frame (1). Attach the handlebars (8) to the frame (1) using the spanner (9) and fixing screw (7). Fix the bell (10) to the
handlebars (8). Put the pull rod (20) in the opening on the left side of the fork (4) and fix the other end under the frame ( 1)
at the point of attachment of the parent handle (Fig. C). Use the fixing screw (12) to attach the basket (11) to the frame (1)
(Fig. D). Attach the backrest (15) and the guardrails (14) to the seat (13). Then place the seat nut (16) and do not forget to
install the harness (Fig. E). Place the assembled seat facing or back to the direction of travel on the frame and tighten the nut
(23) underneath the frame (Fig. F). Insert the visor (17) in the sides of the backrest (15). Fix the cupholder (19) to the parent
handle (18) and insert it in the hole on the frame until the latch is locked (Fig. G).

Adjusting:

Cover location − press the red buttons on both sides of the cover and set in a convenient position. You can also use buckles
on top of the cover.
Footrests − depending on the level of child development, the footrests can be folded to enable the child to ride the tricycle.
WARNING! Whenever the parent's handle is mounted and the footrest is unfolded, the wheel lock should be disengaged so
that the pedals rotate freely without causing the wheel to move (transmission off). Without disengaging the lock, feet may
be crushed or injured! After removing the parent handle, fold up the footrest and engage the wheel lock so that the pedals
set the wheel in motion (transmission on).
Harness − adjust the length to hold the child firmly, but not to block movements.
Seat position − the seat can be adjusted forwards and backwards, and turned rearwards. To do this, unscrew the nut (22) and
set the appropriate position. After tightening, make sure the seat is securely fastened.
Folding the rear wheels − slightly lift the tricycle and push the red button under the frame, rotate the rear wheels forwards.
Older children can ride without a backrest − slide the seat cover down, remove the backrest unlocking the levers on its sides,
rotate the guardrails 90° backwards and pull out. To ride without the backrest, the child should wear additional harness which
is located under the seat.
Adjusting the length of the parent handle − unfold and lock in a comfortable position.
III Maintenance and cleaning
Seat cover, backrest, handlebars cover: Remove from the frame. Wash at max. 30°C, gentle process. Do not bleach. Do not
dry in a tumble dryer. Do not iron. Do not dry clean.
Visor: Do not wash. Do not bleach. Do not dry in a tumble dryer. Do not iron. Do not dry clean. Clean with a clean and damp
cloth using mild soap. Allow to air dry. Do not immerse in water.
Frame: Clean the metal frame with a soft, clean and damp cloth using mild soap.
Storage
Keep out of the reach of children.
Name
17
Part number
13 Seat
14 Guardrails
15 Backrest
16 Seat cover
17 Visor
18 Parent handle
19 Cupholder
20 Pull rod
21 Mudguard fixing screw
22 Front basket
23 Seat nut
24 Mounting spanner
Name