Auxiliary Function Selection; Warning Symbols - Beko DPU 8306 GXE Bedienungsanleitung

Operating the product

5.8 Auxiliary function selection

Audio warning
Machine will give an audio warning when the
programme is completed. If you do not want
the machine to give an audio warning, press
the Volume button repeatedly until an "x" sign
appears on the display. Use the same button to
adjust the volume.
C
You can activate this function either before
or after the programme starts.
Cancel Audio warning
audio warning level 1
Dryness level
Used to adjust the required dryness level. More
drying is performed compared to default settings
when "+" sign appears and less drying is
performed when "-" sign appears. Programme
duration can vary depending on selection.
C
You can activate this function only before
the programme has started.
Anti-creasing
You can use Anti-creasing function to prevent
laundry from creasing if you will not immediately
take the laundry out after the program has come
to an end. This function rotates the laundry every
240 seconds for 2 hours to prevent creasing.
In the first display image below, anti-creasing is
activated but programme is still running. Drying
cycle is completed and Anti-creasing step has
started in the second display image.
Dryer / User Manual
Audio warning Audio warning
level 2 level 3
C
Press Anti-creasing button to activate
this function.
Changing the contrast
You can adjust display contrast in order to make
the symbols on the display clearer. It may be
necessary to change the contrast setting of the
display especially when the dryer is installed on
the washing machine.
Press and hold the Cycle / Time button for 3
seconds.
When contrast is changed, all symbols on display
will appear for 3 seconds in order to indicate that
the process is completed.
C
Perform the same procedure to revert back
to the previous contrast setting.

5.9 Warning symbols

C
Warning symbols may vary according to
the model of your machine.
Lint filter cleaning
When the programme is completed, a warning
symbol will appear to remind that the filter needs
to be cleaned.
C
If the Filter Cleaning symbol flashes
continuously, refer to "Troubleshooting"
section.
Water tank
When the programme is completed, a warning
symbol will appear to remind that the water tank
needs to be drained.
If the water tank becomes full while the
programme is running, warning symbol will
start to flash and the machine will switch to
standby. Drain the water in the water tank and
press Start / Pause / Cancel button to resume
the programme. Warning symbol turns off and
programme resumes operating.
53 / 64 EN