Troubleshooting - Beko DPU 8306 GXE Bedienungsanleitung

Troubleshooting

8
Drying process takes too much time.
Pores of the lint filter are clogged. >>> Wash the lint filter with warm water.
ƒ
ƒ Filter drawer is clogged. >>> Clean the sponge and the filter cloth in the filter drawer.
ƒ Ventilation grids on the front side of the machine are blocked. >>> Remove the objects (if any)
that block ventilation in front of the ventilation grids.
Ventilation may not be sufficient since the room where the machine is installed is very small. >>>
ƒ
Open the door and windows of the room to avoid the room temperature increase too much.
Lime deposit has built up on the dampness sensor. >>> Clean the dampness sensor.
ƒ
ƒ Excessive laundry might have been loaded in. >>> Do not overload the dryer.
ƒ Laundry might not be spun sufficiently. >>> Spin your laundry at a higher speed in your washing
machine.
Laundry comes out wet at the end of drying.
A programme suitable for the laundry type might have not been used.>>> Check the
ƒ
garment tag and select a programme suitable for the fabric type or use the timer
programmes additionally.
Pores of the lint filter are clogged. >>> Wash the lint filter with warm water.
ƒ
Filter drawer is clogged. >>> Clean the sponge and the filter cloth in the filter drawer.
ƒ
Excessive laundry might have been loaded in. >>> Do not load the dryer in excess.
ƒ
Laundry might not be spun sufficiently. >>> Spin your laundry at a higher speed in your
ƒ
washing machine.
Dryer does not switch on or the programme does not start. Dryer does not start when it is
set.
It might have not been plugged in. >>> Make sure that the machine is plugged in.
ƒ
The loading door is ajar. >>> Make sure that the loading door is closed securely.
ƒ
Programme is not selected or the Start / Pause button is not pressed. >>> Make sure that
ƒ
the programme is selected and it is not in the Pause position.
"Childproof lock" might have been activated. >>> Deactivate the Childproof Lock.
ƒ
Programme is interrupted without any cause.
The loading door might not be closed securely. >>> Push the loading door to close until
ƒ
you hear a locking sound.
A power failure might have occurred. >>> Press Start / Pause button to start the
ƒ
program.
Water tank may be full. >>> Drain the water tank.
ƒ
Laundry has shrunk, become felted or deteriorated.
A programme suitable for the laundry type might have not been used. >>> Check the
ƒ
garment tag and select a programme suitable for the fabric type.
Water leaks from the loading door.
Lint has accumulated on the inner surfaces of the loading door and on the surfaces of the loading
ƒ
door gasket. >>> Clean the inner surfaces of the loading door and the surfaces of
the loading door gasket.
Dryer / User Manual
63 / 64 EN