Parasol Operation; Opening Parasol - Schneider Schirme Rhodos Twist Montage- Und Bedienungsanleitung

•
Working in a team of two, place the paving slabs weighing at least 25 kg (50 x 50 x 5 cm)
in the cross base as shown. The total weight of the four paving slabs must be minimum
100 kg.
•
Working in a team of two, carefully place the parasol (H) as shown on the tube. Make
sure that the parasol is properly aligned. Prevent the parasol from falling, as this could
damage it.
•
Secure the parasol (H) by tightening the screw with grip (J).
4

Parasol operation

For efficient use of the parasol, it comes with the following adjusting functions:
•
Tilting parasol
•
Rotating parasol
•
Tilting canopy
These functions ensure optimum shading during the entire day without having to reposition the
parasol.
4.1

Opening parasol

To open the parasol, proceed as follows (see also fig. 4-1):
•
Insert the crank (I) as shown in the hole for the "OPEN – CLOSE" function in the crank
housing and push it in to the stop (1).
Strong wind and gusts can damage the parasol
➢ Tilting the parasol too far significantly increases the surface
exposed to wind, so that the parasol might become damaged
or topple over in windy weather.
➢ Damage resulting from this is not covered by our warranty. As
the user, you are responsible for using the parasol only as
intended.
Open the parasol with special caution
➢ Do not open the parasol under windy conditions.
➢ Make sure that the braces of the parasol do not become
jammed. It may be necessary to pull the ends of the braces
slightly outward.
➢ Ensure that there are no obstacles (walls, table, trees, etc.)
within the opening range of the parasol.
91