Assembly Of Cross Base; Assembly Of Parasol - Schneider Schirme Rhodos Twist Montage- Und Bedienungsanleitung

3.4

Assembly of cross base

To assemble the base plate, proceed as follows (see also fig. 3-1):
•
Place the two cross bases (A + B) onto each other as shown.
•
Bolt both parts to the rotating plate (D). Use the screws M8x20 (F) and one washer (G) for
each screw.
•
Bolt the tube (C) to the rotating plate (D). Use the screws M8x14 (E) and one washer (G)
for each screw.
•
Place the cover cap (L) on the rotating plate as shown. The notch in the cover cap must
be at an equal distance from the tube on all sides. Otherwise, the cover cap may be
damaged by the tube at the next assembly step.
3.5

Assembly of parasol

To install the cross base and the parasol, proceed as follows (see also fig. 3-2 and 3-3):
•
Position the cross base where you wish to place the parasol.
•
Make sure that the ground under the base is firm and level.
90
After assembly, the tube (C) tilts backward by approx. 3°.
This is intentional and thus not a reason for complaint. The angle
ensures that the tube is sightly tilted forwards when the parasol is
opened. In addition, this arrangement enhances the visual impact
of the product.
The parasol weighs approx. 30 kg.
➢ Persons must never carry loads of more 23 kg on their own.
➢ To lift and carry the parasol, always work in teams of two, or
use suitable lifting gear.
➢ Otherwise, you might suffer damage to your health (e.g. back
strain, injury from falling loads).
Each paving slab weighs at least 25 kg.
➢ Persons must never carry loads of more 23 kg on their own.
➢ To lift and carry paving slabs weighing around 25 kg each,
always work in teams of two, or use suitable lifting gear.
➢ Otherwise, you might suffer damage to your health (e.g. back
strain, injury from falling loads).