Electrolux GA55SLIWE Benutzerinformation Seite 22

22 www.electrolux.com
12.1 The washing and drying results are not satisfactory
Problem
Poor washing results.
Poor drying results.
There are whitish streaks or
bluish layers on glasses and
dishes.
There are stains and dry wa‐
ter drops on glasses and
dishes.
The dishes are wet.
The interior of the appliance
is wet.
Unusual foam during wash‐
ing.
Traces of rust on cutlery.
Possible cause and solution
• Refer to "Daily use", "Hints and tips" and the
basket loading leaflet.
• Use more intensive washing programmes.
• Clean spray arm jets and the filter. Refer to "Care
and Cleaning".
• Tableware has been left for too long inside the
closed appliance.
• There is no rinse aid or the dosage of rinse aid is
not sufficient. Adjust the rinse aid level to a higher
level.
• Plastic items may need to be towel dried.
• For the best drying performance, activate XtraDry
and AirDry.
• We recommend to always use rinse aid, even in
combination with multi-tablets.
• The released quantity of rinse aid is too high. Ad‐
just the rinse aid level to a lower level.
• The quantity of detergent is too high.
• The released quantity of rinse aid is not sufficient.
Adjust the rinse aid level to a higher level.
• The quality of the rinse aid can be the cause.
• For the best drying performance, activate XtraDry
and AirDry .
• The programme does not have a drying phase or
has a drying phase with low temperature.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the cause.
• The quality of the multi-tablets can be the cause.
Try a different brand or activate the rinse aid dis‐
penser and use rinse aid and multi-tablets together.
• This is not a defect of the appliance. Humid air con‐
densates on the appliance walls.
• Use the detergent designed specifically for dish‐
washers.
• There is a leak in the rinse aid dispenser. Contact
an Authorised Service Centre.
• There is too much salt in the water used for wash‐
ing. Refer to "The water softener".
• Silver and stainless steel cutlery were placed to‐
gether. Avoid putting silver and stainless steel
items close together.