Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Turn off the appliance first. Remove all content. Shurely tape down all lose items inside
your appliance. Tape doors shut. Be sure the device stays in the upright position during
transportation.
19 Troubleshooting
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
Attention
► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.
The following table assists in localizing and rectifying minor faults.
Fault
Device is not cold enough. Check the temperature control setting.
The light does not work.
Vibrations & too much
noise & door does not
close properly
The display does not work.
Buttons are not functional.
Compressor will not start
Dew on the surface of
cabinet：
18.4 Moving the appliance
19.1 Safety notices
19.2 Fault indications and rectification of faults
Possible Cause
External environment may require a higher setting.
The door is open too often. The door is not closed completely.
The door seal does not seal properly.
The device does not have the correct clearance. Defrost the
device.
Contact customer service.
Check to assure that the device is level. Check the fan.
Components are loose. Device touches the wall. The door is
reversed and not properly installed.
The seal is weak. The shelves are out of position.
Pull out the mains plug, wait 2 minutes, plug in the mains plug
again. If this does not solve the problem, then please contact
customer service
Room temperature is lower than desired temperature.
The surface of the device especially the glass door appear
some frost if item in a damp room. This is due to the moisture
in the air coming into contact with the cabinet. Please wipe it
away with dry cloth.
.
43
Werbung
Inhaltsverzeichnis
Fehlerbehebung
