Safety Regulations - SEH PS104 Schnellinstallationsanleitung

 Safety Regulations
English [en]
Print servers are active network components for printers in office environments
and are designed for the direct integration of printers into networks.
Before starting the initial setup procedure and during the operation of the print
server, please note the following safety regulations. Their purpose is to protect
yourself and others from personal injuries, and avoid damage to the equipment.

Read the documentation and make sure that your system meets the
requirements listed therein.

The device must only be connected to the mains and to the network by
qualified personnel.

Avoid contact with humidity or liquids.

The device must only be connected and operated if it is in perfect condition.

The devices must not be operated in dusty places and direct sunlight.

Make sure that no-one steps on or stumbles over the cables.

If the supplied power cord cannot be used in your country, acquire an
appropriate power cord that suits national provisions. For more information,
please consult your retailer.

The device must be connected to a socket with protective contact.

Position the device in a way that guarantees that the socket for the
connection of the power cord is in the proximity of the device and is easily
accessible. Make sure that the device can be separated easily from the
network. A damaged power cord must be replaced immediately. For more
information, please consult your retailer.

Do not connect a telephone cable to the RJ-45 connector. The RJ-45
connector may only be connected to SELV voltages. For the connection to the
RJ-45 connector only STP cabling (category 5 or better) may be used. The
shielding must fit flushly to the connector.

Only use cables conforming to IEEE 1284 as data cables. The shielding must fit
flushly to the connector.
Quick Installation Guide 3