Inhaltsverzeichnis
Werbung
Inbetriebnahme
Abb. 39: Script-Editor
The line numbers that are displayed next to the script are informational only and are not used in
the scripts themselves. Commands can be added by typing them in directly or by using the
command selection tool, located at the right hand side top corner. Make sure you are at the
right position in the script editor when adding a command with the commands tool. When
adding a command with the commands tool, the appropriate fields regarding your xxter
configuration will be added as links automatically. This allows a quick and easy way to add
correct commands using the editor.
After you have added one or more commands in the editor, you can verify if they are valid by
clicking the "Save and check" button. Your current script will be checked and redisplayed in the
editor. All lines that are correct will be displayed in black. All lines in red indicate it contains an
error somewhere on that line. Comment will always be displayed in green.
After correcting or adding lines, you can easily verify the script again by using the "Save and
check" button. When everything is correct you can use the "Save and close" button to close the
editor.
Note: scripts that contain errors can be saved and started. However the lines that contain errors
(and are displayed in red) will not be executed during the execution of the script. xxter will skip
them and continue with the next line.
KNX Technisches Handbuch 1373-1-8902 / 2CKA001373B8902
│57
Werbung
Inhaltsverzeichnis
