Konig + Neurath LIFE.S Konferenz Montageanleitung Seite 45

Reset (manual reset)
When getting started or in the case of malfunction (e.g.power cut)
As the control panel will automatically switch to energy save mode
after a few seconds, it has to be deactivated first.
To do this, press the UP or DOWN button briefly. Now press the UP
and DOWN buttons at the same time and hold down until the table
switches off automatically.
Successful reset is confirmed by an audible signal from the control
panel. Now release the buttons. The motorised height adjustment
feature of this table can be used normally again.
Safety instructions:
During the reset process, the collision cut-out
is inactive! Beware of the risk of crushing. Please
ensure that there are no objects or persons in
the hazard area (the total potential lift and move-
ment area for all components) and that they can-
not be pulled into the hazard area.
Further information on motorized or manual
controls can be found at www.kesseböhmer.com
42