ECG ERM 10510 FCBM Bedienungsanleitung Seite 22

If you will not use the minibar for longer period of time
If you do not intend to use the appliance for a long time, do the following:
• Unplug the minibar from the electrical socket.
• Clean the interior of the appliance and wipe it dry. Leave the door slightly ajar to avoid moisture build-up
inside the appliance.
• If you do not use the minibar for a long period of time and do not clean it regularly, it may create an
unpleasant odour and mould.
GB
MAINTENANCE
Defrosting
Once the minibar is in operation, the surface freezes. This is part of a completely normal operation. However,
if the ice layer is greater than 3 mm, the refrigerator must be defrosted and cleaned to avoid excessive power
consumption and inefficient performance.
Never use sharp or metal objects to remove the ice when defrosting. You could damage the minibar.
1. Remove all drinks from the minibar and unplug it from the electrical socket.
2. Return the temperature selector to its original position after defrosting.
Cleaning
1. Unplug the minibar from the electrical socket.
2. Wash the inside of the appliance using a neutral detergent.
3. Dry all surfaces thoroughly.
Note: Do not use aggressive cleaning agents. To ensure efficient operation of the appliance, the back and
bottom of the appliance should also be carefully cleaned. Clean the sealing using soapy water.
• Unplug the minibar and remove all beverages before you move it.
Note: Never grab the appliance by the door.
TROUBLESHOOTING
Read the instructions below before you decide to claim a malfunction. Maybe you can solve the problem
yourself.
Problem
Cooling does not work or is
ineffective.
Unusual or excessive noise
during operation.
The outer surface is wet.
The interior surface is wet.
22
Solution
• Check the power cable and fuses.
• Check the temperature setting. Set the appropriate temperature
according to the instructions in the chapter "Tips for effective cooling".
• Minibar is overloaded.
• The minibar is exposed to direct sunlight or a heat source.
• The door was opened for too long.
• The appliance is not on a sufficiently flat and stable surface or touches
other objects.
• You hear a coolant flow during the compressor operation. This is
entirely normal.
• The appliance is close to a source of water. Dry it thoroughly and move
it away from the water source.
• The door was opened too frequently or for too long.
• Check if the door seal is in order.