Sharp K-70V19IM2-EU Bedienungsanleitung Seite 12

WIRING AND SAFETY OF
BUILT_IN OVEN
The instructions given below must be
followed explicitly during wiring:
– The grounding cable must be connec-
ted via the screw with the grounding
mark. The supply cable connection
must be carried out as shown in Fi-
gure 6. If there is no grounded outlet
conforming to regulations in the ins-
tallation environment, call the Authori-
zed Service Centre immediately.
– The grounded outlet must be in close
proximity to the appliance. Never use
an extension cord.
– The supply cable should not contact
the product's hot surface.
– In the event of any damage to the
supply cable, make sure to call the
Authorized Service Technician. The
cable must be replaced by the Autho-
rized Service technician.
– Wiring of the appliance must be per-
formed by the Authorized Service
technician. A H05VV-F type supply
cable must be used.
– Faulty wiring may damage the appli-
ance. Such damage will not be cove-
red under the warranty.
– The appliance is designed to connect
to 220-240V~. If the electricity is diffe-
rent than the value given above, call
the Authorized Service Centre imme-
diately.
– The manufacturer declares that its
bears no liability of any kind for
damage and loss arising from not
complying with safety standards!
– Wiring of the appliance must be per-
formed by the Authorized Service
technician. The appliance is
– designed to connect to 220-240V~
electricity. If the electricity power line
is different than the value given, call
the Authorized Service Centre imme-
diately. The appliance is designed for
using with a plug or fixed connection
to the power line. It is necessary that
you install a double pole switch bet-
ween the product and the electricity
supply (power line), with a minimum
gap of 3 mm between the switch con-
tacts. (20A rated, delayed function
type).
3.4. GENERAL WARNING AND
PRECAUTIONS
Your appliance is produced in confor-
mity with the relevant safety instruc-
tions relating to electrical appliances.
Maintenance and repair works must be
performed only by Authorized Service
technicians trained by the manufactu-
rer. Installation and repair works, per-
formed without observing the rules may
be hazardous.
The outer surfaces is heated while your
EN - 10