Environmental Specifications - Ricoh D8600 Bitte Zuerst Lesen

3. Installing the Machine (Installed by a Contractor)

Environmental Specifications

The following table lists the environmental specifications for the machine:
Temperature
Humidity
Maximum altitude
Power
• The machine is designed for indoor use.
• The machine is equipped with an infrared touch panel. Do not use the machine in a location
exposed to strong light, such as direct sunlight. If you use the machine in a location exposed to
strong light, the machine may not operate properly.
• We recommend that you take the necessary measures to prevent the machine from falling over
after it is installed.
• If you install the machine in a location exposed to high temperatures, we recommend that you
specify a low humidity (60% or lower) when operating the machine.
• This machine uses an infrared touch panel. Do not put close to this machine any equipment that
uses infrared. Doing so may affect the operation of the equipment or may make operation of the
remote control ineffective.
• If you put RICOH Unified Communication System P3500 on the shelf board of the stand,
place the front of the light receiver of the remote control toward you, setting the machine on
the front end of the shelf board.
• When using other equipment with an infrared receiver, keep it as far away from this machine
as possible (3m (118.2 inches) or more is recommended). Or, place the equipment so that
the infrared light emitted directly from the inside of the main body frame and the indirect light
from reflection/diffraction do not enter the remote control light receiver of the equipment.
• When you use more than two of these machines, the infrared from the touch sensors may
affect each other and cause malfunctions. Position them and use them as far away from each
other as possible.
20
Environment Specifications
0-32°C (32-89.6°F)
10-80% (without condensation)
2,500 m (8,202 feet)
AC 100-240 V, 50/60 Hz