Unpacking; Assembly - Pfannenberg PWI 6302C/ 115 V Betriebsanleitung

GB
3.3

Unpacking

WARNING
Danger of accidents due to the heavy weight of the units
Uncontrolled movements of the units during assembly can cause accidents.
 Use suitable lifting equipment and secure units to prevent accidents.
 Also secure assembled components.
CAUTION
Danger of injury due to sharp edges
 For manufacturing reasons, the metal edges of the unit may have burrs.
 Wear gloves during service and assembly work.
 Perform a visual inspection for transport damage when unpacking the air/water heat exchangers.
Take note of any loose parts, dents, scratches, visible loss of oil etc.
 Inspect the packaging material for any loose functional parts before disposal.
 Reported any damages to the freight carrier immediately. Observe the "Terms for Cases of Damage".
 Precise information about defects, including possible photos must be provided for the handling of warranty
claims. Always specify the type designation and serial number.
 The "General Terms for Deliveries and Services" of ZVEI (Zentralverband der Elektrotechnischen Industrie;
Central Association of the Electrical Engineering and Electronics Industry , in Germany) according to the latest
revision apply.
3.4

Assembly

DANGER
Life-threatening danger due to electric shock
Live units and exposed connection cables can generate an electric shock and cause severe accidents.
 Work on electrical connections must be carried out exclusively by trained, qualified electricians.
 Before assembly, de-energize all supply lines to the separate fuse or a main switch, disconnect the system
and secure to prevent re-connection.
 Test to ensure the absence of voltage on the unit.
CAUTION
Danger of crushing during assembly of the unit
There is a danger of crushing between the switch cabinet and frame of the unit during assembly.
 Keep body parts out of the space between the frame and unit cut-out.
 Work carefully and wear gloves.
NOTE
Switch cabinet installation hazard due to assembly chips
When mounting the air/water heat exchanger cut-outs, assembly chips can fall into the switch cabinet.
 When assembling the switch cabinet, protect against impurities and use protective covers.
Operating manual PWS and PWI 6302 C 086100048 © Pfannenberg GmbH Page 10 / 31