Klarstein 10031938 Bedienungsanleitung Seite 16

EN
16
6 During drying process, you can change or check the drying time. Press the "TIMER"
button first, then press the „+" or „-" button. Press "TIMER" button twice, you can
check the setting time.
7 During drying process, you can change or check the drying temp. Press the "TEMP"
button first, then press the „+" or „-" button. 5 seconds after finish changing or
checking, LED screen changes to time mode.
8 During drying process, press the "Start/Reset" button twice, all functions will be
paused. Press "Start/Reset" button one more time, then revert to work in the mode
before pausing.
9 In any function mode, press the "Start/Reset" button for more than 3 seconds,
current work status stops and all setups are cleared. The dehydrator gets back to
standby mode.
10 In standby mode, you can press the "Start/Reset" button directly to get into default
mode ( TIME : 10 hours TEMP: 70 ). You also can change the drying time and temp
if needed.
1 1 When the set time counts down to „0:00", the heating element stops working first.
The fan will continue running for 10 seconds and the buzzer rings 20 times „beep"
sound (1 time/second). The LED screen gets into standby mode at default time and
temp value.
Note: Make sure that the fan base is always in place when operating the dryer. If
you do not have time to dry all the food in one day, you can dry them the next day.
In this case, you should store the food in a container/polyethylene bag and put it in
the freezer.
12 Unplug the unit from the power point.
Note: It is recommended to stack at least 3 working trays, whether you have food on
them or not.