Before Operating; Setting Up The Device - Block SR-200 MKII Bedienungsanleitung

Before operating

Before you can use your Internet radio, the streaming functionality or the operation via smart phone app, you need:
1. A fast internet connection.
2. A router, preferably with WLAN (wireless access point).
3. In case your router does not provide WLAN connection, you also could connect your equipment using
Ethernet cable.
4. Later, when setting up the device, you choose between wireless (WLAN) and cable connection.
5. If your wireless network is protected with Wired Equivalent Privacy (WEP) or with Wi-Fi Protected Access
(WPA), you will need a WEP or a WPA code, so that your Internet radio can be connected to the router.
6. Before proceeding, make sure that your wireless network is turned on and has a broadband internet
access.
7. In case of problems while connecting your device to the router, please try to solve them using the manual
instructions of the router.

Setting up the device

1. Connect the FM and DAB + telescopic antenna to the device. Then pull the telescopic aerial to full length.
Later, when setting up your channels, you can optimize the reception quality just changing the angle of
inclination and the tilt angle of the aerials.
2. If you want wirelessly to connect your SR-200 MKII to the Internet via an existing wireless Network, please
mount the included WLAN antenna
3. If you want to connect your SR-200 MKII to the Internet via Ethernet (wired), please connect your router to
the Ethernet jack of the SR-200 MKII using a RJ-45 cable.
4. Connect the connection cable of the enclosed power supply unit to the device and plug this into a power
outlet
41