Manual Wlan Installation; Manual Lan Installation (Ethernet) - Block SR-200 MKII Bedienungsanleitung

Manual installation WLAN
Should any problem appear while setting up the wizard, or you want to make a manual setup, please proceed
as follows:
1. Press and hold the „Menu" button on the remote control. Use the arrow buttons on the remote to select
System Settings / Internal Settings / Manual Settings / Wireless.
2. In the next step, select DHCP active. This is the default setting for all common Internet routers and it takes
a lengthy network configuration. * Confirm the setting.
3. Now enter the name of your WLAN network (SSID), be sure to use correct spelling and case. Confirm with OK.
4. Select the type of password protection (usually WPA2 and AES). If there is any doubt, consult the manual of
your router.
5. Now enter the password of your WLAN network, be sure to use the correct spelling and case. Confirm with OK.
6. Now the router and your SR-200 MKII should be connected and an Internet connection exists, the device
will display "Connected".
Manual Installation Cables (Ethernet)
Should you want to connect the SR-200 MKII to the router using the Ethernet cable, instead of using the WLAN
connection, please proceed as follows:
1. Connect a free LAN jack to your router and the LAN jack on the SR-200 MKII to an Ethernet cable (RJ-45).
2. Press and hold the „Menu" button on the remote control. Use the arrow keys on the remote control to
select System Settings / Internal Settings / Manual Settings / Cables.
3. In the next step, select DHCP active. This is the default setting for all common Internet routers and it takes
a lengthy network configuration. * Confirm the setting.
4. Now the router and your SR-200 MKII should be connected and an Internet connection exists, the device
will display „Connected".
*
Should you have deactivated the DHCP function on your router, please select DHCP inactive. In this case, you must configure the network, you
should be aware of the applicable rules and information. For extended configuration, you may need the MAC address of your block device. These
can be found under Main menu / System settings / Inter- net settings / Show settings / Mac address
43