Amplifiers And Sound Settings - Block SR-200 MKII Bedienungsanleitung

Amplifiers and sound settings

The SR-200 MKII is equipped with a high-quality Class-D amplifier with a power of 2 x 20 watts at 6 Ohm (RMS).
Use the following settings to change the sound:
Volume:
By pressing the „VOL +" and „VOL-" buttons on the remote control or the multifunction knob on the device, you
can change the volume of your system.
Please note that the SR-200 MKII can have different loudspeakers for different signal sources with the same
volume setting. This is not a defect, but is caused by different input levels of the signal sources applied.
Equalizer:
Press and hold the „Menu" button on the remote control until the menu appears on the display. Select System
Settings / Equalizer using the arrow buttons.
Now, by repeated pressure, you can choose under the following pre-settings: Normal, Centric, Jazz, Rock,
Soundtrack, Classic, Pop, News, and My Equaliser (EQ).
Under My EQ setting, you can define bass and treble values. For this, use the „up arrow" button on the remote
control to increase the value and the „down arrow" key to decrease the value. To exit the menu, press the „Left
arrow" key.
Repeat this process for all values, and then press the „Left Arrow" button again.
Now you are asked if you want to save the settings. Please confirm with Yes. Your settings are then available
under the menu item My EQ.
44