The Remote Control; Before Operating; Setting Up The Device - Block SR-50 Bedienungsanleitung

Remote control
1 3
5 6
4 17
13 14
7 8
15
20
9
13
10 12
11
16
2
18
21
19
40
1. „Standby" button: switches the device to „Clock" mode, the display
will show the time and the date.
2. „Mute" button: switches the sound off.
3. „CD" button: ejects the CD.
4. „Mode" button : By pressing, the display switches to the overview
mode. You can now use the multifunction knob or the arrow keys on
the Remote control select the music source
5. Button „Menu/Info": One or more short presses will display
additional information about the music source (if any) on the display.
Long press calls up the menu of the device.
6. „FOLDER DOWN" button: Only for CD operation on MP3 CDs with folder
structure.
7. „Back" button: on radio mode, the device searches the previous lo
wer transmitter.
8. „Forward" button: on radio mode, the device searches the next higher
transmitter.
9. Arrow upwards: on FM mode to increase the frequency in 0.05 MHz . In
menu to select the different points.
10. Arrow to the left: to reach the previous setting in the menu.
11. Arrow down: in FM mode by the frequency in 0.05 MHz increments to
reduce. To select the different points in the menu.
12. Arrow to the right: to access selected functions in the menu.
13. "Play" button
14. „Stop" button.
15. „Volume +" button: increases the volume
16. „Volume -" button: reduces the volume
17. „FOLDER UP" button: Only for CD operation on MP3 CDs with folder
structure.
18. Button „1 - 10": on radio mode, recalls on the stored transmitters
19. „P" button: recalls or saves pre-set transmitters in radio mode
20. „EQ" button: Short press calls up the equalizer menu.
21. Taste „SHUFFLE / REPEAT": Press once to start the repeat function for
the current title, press the repeat function twice whole media (for
example, CD, USB, media server) a third press ends all Repeat. Long
press starts the playback of the entire medium in random Sequence,
pressing again for a long time ends this function. Watch out for the
displays at the bottom of the display.

Before operating

Before you can use your Internet radio, the streaming functionality or the operation via smart phone app, you need:
1. A fast internet connection.
2. A router, preferably with WLAN (wireless access point).
3. Later, when setting up the device, you choose between wireless (WLAN) and cable connection.
4. If your wireless network is protected with Wired Equivalent Privacy (WEP) or with Wi-Fi Protected Access
(WPA), you will need a WEP or a WPA code, so that your Internet radio can be connected to the router.
5. Before proceeding, make sure that your wireless network is turned on and has a broadband internet
access.
6. In case of problems while connecting your device to the router, please try to solve them using the manual
instructions of the router.

Setting up the device

1. Pull the telescopic aerial to full length.
Later, when setting up your channels, you can optimize the reception quality just changing the angle of
inclination and the tilt angle of the aerials.
2. Connect the connection cable of the enclosed power supply unit to the device and plug this into a power
outlet
41