Trix H0 22249 Bedienungsanleitung Seite 13

DCC Protocol
Addresses
• Possible addresses: short, long, and m.u. address
• Address range:
1 – 127 (short address, m.u. address)
1 – 10239 (long address)
• Every address can be programmed manually.
• A short or a long address is selected using the CVs.
• A multiple unit address that is being used deactivates the
standard address.
Programming
• The characteristics can be changed repeatedly using the
Configuration Variables (CV).
• The CV numbers and the CV values are entered directly.
• The CVs can be read and programmed repeatedly. (Program-
ming is done on the programming track.)
• The CVs can be programmed, as you desire. PoM (Program-
ming on the layout track) is only possible with those CVs
marked in the CV table. PoM must be supported by your
central controller (see the instructions for your controller).
• The default settings (factory settings) can be produced
repeatedly.
• 14 or 28/126 speed levels can be set.
The speed levels on the locomotive decoder and on the
controller must agree with each other; otherwise, you may
have malfunctions.
• All of the functions can be controlled according to the func-
tion mapping (see CV description).
• See the CV description for the DCC protocol for additional
information.
We recommend that in general programming should be
done on the programming track.
Logic Functions
Acceleration / Braking Delay
• The acceleration and braking times can be set separately
from each other.
• The logical function shut off for ABV (Acceleration / Braking
Delay) can be assigned to any function button by means of
function mapping.
13