Respekta CH 99060 S A Montageanleitung Seite 8

9. Firmly press the chimney shaft against the wall and mark with pencil the two drill
holes through the holes in the chimney stabilize- and mounting plate. (Fig. d)
Fig . d)
10. Remove the chimney from the hood.
11. Drill two 40mm deep holes into the wall at the marked locations using an 8mm
masonry drill.
12. Push the upper (inner) chimney shaft from above into the lower (outer) chimney
shaft.
13. Place the nested chimneys on the hood.
Fig . e)
14. Pull the inner chimney shaft straight up to the ceiling and place one marking line
on the sides of the shaft. (Fig. e)
15. Remove the chimneys from the hood.
16. Hold the upper (inner) chimney mounting bracket (Fig. f) at the top center of the
ceiling between the drawn marks (Fig. e) and mark the drilled holes with the two
holes (Fig. f) in the mounting bracket a pencil.
Fig . f)
17. Using an 8mm masonry drill, drill two 40mm deep holes at the pencil markers and
place two plugs.
18. Fix the inner chimney mounting bracket (Fig. f & g) to the wall with two ST4 ×
40mm screws at the top of the ceiling.
Fig . g )
19. Place the two nested chimneys on the hood.
20. Slide the inner chimney shaft all the way down.
21. Attach the lower chimney stabilize- and mounting plate (Fig. d) to the wall with
two ST4 x 40mm screws.
Fig . h)
22. Fix the lower chimney shaft with two ST4 * 8mm screws on the sides of the hood
(Fig. g).
23. Pull the upper (inner) chimney shaft all the way up and secure it to the mounting
bracket with two ST4 * 8mm screws. (Fig. h)
24. Secure the hood with two ST4 × 30mm screws through the 2 hood fixing eyelets .
(Fig. i)
25. Mount the carbon filters on the sides of the motor. (See user's manual chapter
Fig . i)
"Using the carbon filters").
fi200507ATL 3 / 4 Figures are partially for Illustration only