Factory Setting; Programming The Remote Control - Becker Centronic SunWindControl SWC442-II Montage- Und Betriebsanleitung

Light controller push button
Use the light controller push button to switch the lighting set on and off, or to
dim it.
If the light controller push button is pressed for less than 0.5 seconds, the light-
ing set is either switched ON or OFF.
If the light controller push button is pressed for longer than 0.5 seconds, the
lighting set is dimmed in a sequence of commands, e.g. maximum value, mini-
mum value etc.
Sun threshold value: Intermediate position (25KLux)
Wind threshold value: Left limit stop (2 m/s)
Programming the remote control
Caution
Before programming the transmitter, please check whether the thresh-
old control switches are set to the factory setting. When programming
the transmitter, ensure that you are not located in the operating area of
the sun protection system. Please refer to the operating instructions
for the receiver.
1) Learning the light function
a) Put the light receiver into learn mode
• Switch off the receiver's power supply and reconnect after 5 seconds.
The receiver will then be in "Learn" mode for 3 minutes.
b) Learning the light function
Press the light controller push button and within 3 seconds the "Learn" key and
keep both buttons pressed until the receiver indicates that the learn process has
been successfully completed.
The learn process is now complete.
Factory setting
de
en
fr
nl
19