Herunterladen Inhalt Inhalt Diese Seite drucken

Test Mode - Becker Centronic SunWindControl SWC442-II Montage- Und Betriebsanleitung

Fur sonnen-wind-licht-steuerung
Vorschau ausblenden Andere Handbücher für Centronic SunWindControl SWC442-II:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Assembly and Operating Instructions
Wind threshold control switch
Becker sensor)
This control switch allows you to set the wind threshold values (approx. 2m/s
to 22 m/s).
The wind threshold value can be set to 11 different levels. If you turn the control
switch slowly, the tubular drive makes a clacking sound for each level.
- Left limit stop =
+ Right limit stop =
If the threshold values are changed, these are adopted immediately.
Note
Please ensure that no buttons are pressed when setting the threshold
value. If the wind speed rises above the preset wind threshold, the sun
protection system is retracted and remains closed. The sun protection
system is extended again if the wind speed remains below the preset
wind threshold for approx. 15 minutes.
Sun threshold control switch
Becker sensor)
This control switch allows you to set the sun threshold values (approx. 5KLux
to 100KLux).
The sun threshold value can be set to 15 different levels. If you turn the control
switch slowly, the tubular drive makes a clacking sound for each level.
- Left limit stop =
+ Right limit stop =
If the threshold values are changed, these are adopted immediately.
Note
Please ensure that no buttons are pressed when setting the threshold
value. If the sun intensity rises above the preset sun threshold, the sun
protection system is extended with a time delay of up to 5 minutes. The
sun protection system is retracted again automatically if the sun inten-
sity remains below the sun threshold for approx. 15 minutes.

TEST mode

The TEST mode is activated by adjusting the threshold value.
This mode will automatically end after approx. 15 minutes. Alternatively, the slid-
ing switch can be used to deactivate the test mode immediately.
In the TEST mode, the times for the sunshade function and wind control are
reduced.
18
Level 1: retract when wind speed is low
Level 11: retract when wind speed is high
Level 1: extend when sun intensity is low
Level 15: extend when sun intensity is high
(in combination with a suitable
(in combination with a suitable

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis