Electrical Safety; Assembly And Adjustment; Operation - DeWalt dw059 Handbuch

DO NOT use under wet conditions or in presence of
flammable liquids or gases.
This heavy-duty impact wrench is a professional
power tools.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.

Electrical Safety

The electric motor has been designed for one
voltage only. Always check that the battery pack
voltage corresponds to the voltage on the rating
plate. Also make sure that the voltage of your
charger corresponds to that of your mains.
Your D WALT charger is double insulated
E
in accordance with EN 60335; therefore
no earth wire is required.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organization.
E
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 3 A.
Using an Extension Cable
An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger
(see technical data). The minimum conductor size is
1 mm 2 ; the maximum length is 30 m.
When using a cable reel, always unwind the cable
completely.

ASSEMBLY AND ADJUSTMENT

WARNING: Prior to assembly and
adjustment, always remove the battery
pack. Always switch off the tool before
inserting or removing the battery pack.
WARNING: Use only D
packs and chargers.
Inserting and Removing the
Battery Pack from the Tool (fi g. A)
NOTE: Make sure your battery pack is fully charged.
1. Insert the battery pack (4) into the grip until it
clicks in place.
2. To remove the battery pack, press the two
battery release buttons (5) simultaneously and
pull the pack out of the grip.
Fitting and Removing Sockets (fi g. C)
The tool uses a 1/2" square drive system with detent
pin.
FITTING SOCKETS
• Align the hole (9) in the side of the socket with
the detent pin (10) on the anvil.
• Push the socket (11) onto the anvil (12) until it
snaps into place. Tap it lightly if required.
REMOVING SOCKETS
• Depress the detent pin (10) through the hole (9)
in the socket and pull the socket off the anvil.
Instructions for Use
PRIOR TO OPERATION:
• Make sure your battery pack is (fully) charged.

OPERATION

Instructions for Use
Proper Hand Position (fi g. D)
WALT battery
E
WARNING: To reduce the risk of
serious personal injury, turn tool off
and disconnect battery pack before
making any adjustments or removing/
installing attachments or accessories.
An accidental start-up can cause injury.
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories.
WARNING: To reduce the risk of
serious personal injury, ALWAYS use
proper hand position as shown.
EN GL IS H
33