Electrolux EN3350MOX Benutzerinformation Seite 9

6.1 What to do if...
Problem
The appliance is noisy.
The lamp does not work.
The lamp does not work.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the FastFreeze
or after changing the tem‐
perature.
Water flows inside the re‐
frigerator.
Water flows on the floor.
Temperature cannot be
set.
Possible cause
The appliance is not sup‐
ported properly.
The lamp is in stand-by
mode.
The lamp is defective.
Temperature is set incor‐
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The FastFreeze function
is switched on.
This is normal, no error
has occurred.
The water outlet is clog‐
ged.
Food products prevent
water from flowing into
the water collector.
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
The FastFreeze or Shop‐
pingMode function is
switched on.
ENGLISH
Solution
Check if the appliance
stands stable.
Close and open the door.
Contact the nearest Author‐
ised Service Centre.
Refer to "Operation"/"Control
panel" chapter.
Wait a few hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "FastFreeze func‐
tion".
The compressor starts after
some time.
Clean the water outlet.
Make sure that food prod‐
ucts do not touch the rear
plate.
Attach the melting water out‐
let to the evaporative tray.
Switch off FastFreeze or
ShoppingMode manually, or
wait until the function resets
automatically to set the tem‐
perature. Refer to "Fast‐
Freeze or ShoppingMode
function".
9