Husqvarna 525P4S Bedienungsanweisung Seite 13

To use the correct chain oil
WARNING:
can cause injury to you and the
environment. Waste oil also causes damage
to the oil pump, the guide bar and the saw
chain.
WARNING:
the lubrication of the cutting equipment is
not sufficient. Risk of serious injury or death
to the operator.
WARNING:
that lets the fuel run out before the chain oil.
Use the correct chain oil for this safety
function to operate correctly. Speak to your
servicing dealer when you select your chain
oil.
Note:
This product has an automatic chain lubrication
system. You can also adjust the oil flow. Refer to
adjust chain lubrication on page 22 .
• Use Husqvarna chain oil for maximum saw chain life
and to minimise environmental damage. If
Husqvarna chain oil is not available, we recommend
you to use a standard chain oil.
• Use a chain oil with good adherence to the saw
chain.
• Use a chain oil with correct viscosity range that
agrees with the air temperature.
CAUTION:
runs out before the fuel. In temperatures
below 0°C/32°F some chain oils become
too thick, which can cause damage to
the oil pump components.
• Use the recommended cutting equipment. Refer to
Accessories on page 25 .
To use the product
• Hold the product as close to your body as possible to
get the best balance. Use the harness to support the
weight of the machine and make it easier to handle.
• Make sure that the tip does not touch the ground.
• Do not rush the work, but work steadily until all the
branches have been cut back cleanly.
• Always slow the engine to idle speed after each
working operation. Long periods at full throttle
without any load on the engine can lead to serious
engine damage.
• Always work at full throttle.
703 - 007 - 28.04.2021
Do not use waste oil, which
The saw chain can break if
This product has a function
To
If the oil is too thin, it
• Whenever possible position yourself so that you can
make the cut at right angles to the branch.
• Do not work with the shaft held straight out in front of
you as this increases the apparent weight of the
cutting attachment.
• Cut large branches in sections so that you have
better control over where they fall.
• Never cut through the swelling at the root of the
branch as this will slow down healing and increase
the risk of fungal attack.
13