Remote Control; Accessories - Velleman MONCOLHA7PN Bedienungsanleitung

6. PP button Press PP (6), STORE (7) and PP (6) again to store your personal preferences for the screen
controls.
7. STORE button See "PP button" above.
8. Power indicator Lights when the device is activated.
9. IR Window This window conceals a sensor that receives the signals of the remote control.
10. TFT LCD
11. Connector Input jack.

5. Remote Control

1. Mute button
2. Standby button
3. AV button
4. "+" button
5. SEL button
6. "-" button
7. Volume ↓ button
8. Volume ↑ button
9. Colour saturation ↓
10. Colour saturation ↑
11. Contrast ↓ button
12. Contrast ↑ button
13. Brightness ↓ button Press this button to decrease the brightness.
14. Brightness ↑ button Press this button to increase the brightness of the
6. Safety
• This monitor uses a DC power supply, so mind the polarity and make sure that the regulated supply's voltage lies
between 11 – 14V in order to avoid damage to the parts.
• This TFT LCD monitor is a very sensitive device. Do not shake it and do not strike it. Use the device at a
temperature between 5 and 40°C. Make sure no metal objects penetrate the housing and protect the device
against water. Avoid short circuits as they can damage the monitors.
• You can suffer an electroshock if you try to repair the device yourself. Have a professional repair this device if
necessary.

7. Accessories

• 1 remote control
• 1 cable acts as power cable / video cable / audio cable
• 1 user manual
MONCOLHA7PN
Press this button to turn the audio on/off in case the monitor has a built-in speaker.
Press this button to put the monitor in standby mode and press again to restore normal
operation. Power consumption is minimal in the standby mode.
Used to switch between A/V inputs 1 & 2. AV1 is exclusively audio, AV2 is audio/video.
Press this button to successively increase the values set for brightness, colour saturation,
contrast, hue and volume.
Used to select one of the controls in the following
order : brightness – colour saturation – contrast – hue
– volume. Use button 2 or 4 to adjust the selected
value. Note that you can only adjust the hue in the
NTSC system
Press this button to successively lower the values set
for brightness, colour saturation, contrast, hue and
volume.
Press this button to lower the volume.
Press this button to increase the volume.
Press this button to decrease the colour saturation.
Press this button to increase the colour saturation.
Press this button to lower the contrast.
Press this button to heighten the contrast.
picture.
2 VELLEMAN