Description Of The Equipment - Fimer TT255 AC/DC Bedienungsanleitung

2. DESCRIPTION OF THE EQUIPMENT

10
17 19
18
22
11
6
FIGURE 1:
1
2
3
4
In welding mode, the display is divided into five main parts:
Part 1: State of the machine
Part 2: Meaning of the active buttons (buttons 2, 3, 4, 5 of fig. 1)
Part 3: Value of the measurements set
Part 4: Type of process selection
Part 5: Indicates the values set for the various welding parameters
(to change the set value, highlight the value with knob 10 and press
to confirm; the value is highlighted as a contrast.
Change the value by turning the knob and confirm the new value by
pressing knob 10 again).
Highlighted value: Indicates the welding parameter that is being
changed with knob 10.
VIEWS :
- At start-up, the Fimer logo and the Firmware revision are
displayed.
CONTROL BUTTONS: (2, 3, 4, 5 in fig.1)
Each control button is associated with a specific function shown on
the display.
Fig. 1
20 21
8. USB port: for technical assistance only.
9. Knob for setting the main welding parameter: the main
welding parameter can be set with this knob:
Welding MMA/TIG: sets the welding current.
11. Air grills (must never be obstructed).
12. "-" dinse front connector: negative pole inlet.
MMA Mode: Electrode holder
TIG Mode: TIG Torch.
13. Connector for remote control.
14. "+" dinse front connector: positive pole inlet.
MMA Mode: Ground clamp
TIG Mode: Ground clamp
15. Gas Outlet:
MMA Mode: inactive
TIG Mode: Gas connection to the welding torch
FIGURE 2:
17. ON-OFF switch: turns the machine on and off.
18. Input cable: connection cable to the mains power equipped.
19. Welding gas inlet
MMA Mode: Not used
TIG Mode: GAS connection to the cylinder
20. CONNECTOR OF THE POWER SUPPLY UNIT (OPTION)
Fig. 2
21. FUSE OF THE POWER SUPPLY UNIT
22. CAN BUS: Programming connector
1. Graphic display :
The display 5.7 inch
Part 2
color'' shows different
Part 3
screens depending on
whether the machine is
Part 4
in welding mode or
setting mode.
Part 5
7. SD slot: this slot, covered with a
rubber cap, contains the SD-Card
provided with the machine; without
the card, the machine will be
inactive and a warning message
will appear on the screen.