ZANKER KOB25722XK Benutzerinformation Seite 17

use the oven if the door gasket is damaged. Contact an
Authorised Service Centre.
To clean the door gasket, refer to the general
information about cleaning.
Removing the shelf supports
To clean the oven, remove the shelf supports.
Caution! Be careful when you remove
the shelf supports.
1. Pull the front of the shelf support away from the
side wall.
2. Pull the rear end of the shelf support away from the
side wall and remove it.
1
Install the removed accessories in the opposite
sequence.
Removing and installing door
The oven door has two glass panels. You can remove
the oven door and the internal glass panel to clean it.
Read the whole "Removing and installing door"
instruction before you remove the glass panels.
The oven door may close if you try to
remove the internal glass panel before
you remove the oven door.
Caution! Do not use the oven without
the internal glass panel.
1. Open the door fully and hold both hinges.
2
2. Lift and turn the levers fully on both hinges.
3. Close the oven door halfway to the first opening
position. Then lift and pull forward and remove the
door from its seat.
4. Put the door on a soft cloth on a stable surface.
17