Vaude Taurus UL 2P Bedienungsanleitung Seite 11

3. Sort the poles and assemble them.
4. Insert the poles into the pole sleeves. Note: the pole sleeve along the
tent's longer axis is closed on one end. Insert the tent pole with the tip-
ends into that pole sleeve, and then the tent pole with the open ends into
the pole sleeve along the shorter axis (a).
5. Only after both poles are inserted into the sleeve, attach the ends with the
matching pins and tense the poles (b), the tent will now stand unaided.
6. Attach the ridgepole above the main frame, use the finger loops (C).
7. Anchor the porch and, where necessary, use guy ropes. Please note: the
finger loops do not suffice to secure the tent during stormy weather.
8. Ensure there is sufficient ventilation, for increased air circulation open the
various entrances (D).
TakE Down – gEnEral inSTrUCTionS:
• Remove everything from the tent's interior.
• Freestanding tents can be gently shaken out to remove leaves, sand, and
other debris.
• Turn the tent over with floor facing upward and allow it to dry a bit longer.
• If it's not possible to dry the tent completely before packing it, this should
be done within 12 hours to prevent the risk of mold and mildew growth.
• As in the tent set up, never pull the poles out of the pole sleeves; rather
push them through.
• When storing a tent in its stuff sack, make sure that stakes and poles don't
press against the tent fabric and damage it.
• Before taking down your tent, close all zips and roll up the guy lines.
That way you won't have to untangle them when it comes time to set the
tent up again, and pitching is that much easier.
DiSmanTling – "moDEl-SpECifiC":
1. Unhook the long poles from over the opening.
2. Detach the poles from the base and let the tent fold in on itself.
3. Slide out the poles (do not pull).
4. Fold up the tent poles and roll up with the tent, if possible. Do not force
the poles into the storage bag if it is full.
GAL_TENT_Taurus_UL.indd 11
TaUrUS Ul 2p 11
08.08.2011 12:00:43