Chicago Pneumatic CP3119-123X Bedienungsanleitung Seite 3

Original instructions.
© COPYRIGHT 2010, CHICAGO
PNEUMATIC
All rights reserved. Any unauthorized use
or copying of the contents or part thereof
is prohibited. This applies in particular to
trademarks, model denominations, part numbers
and drawings. Use only authorized parts. Any
damage or malfunction caused by the use of
unauthorised parts is not covered by Warranty or
Product Liability.
INSTRUCTIONS
This product is designed for removing
material using abrasives. No other
use permitted. For professional use
only. Before servicing the power tool,
the supply of compressed air must be
disconnected or shut off.
If a grinding wheel is broken, a careful
investigation shall be made by the
user to determine the correct cause.
If the failure occurs while the tool is in
operation, the wheel manufacturer and
promptly.
When disposing of components,
lubricants, etc ... ensure that the
relevant safety procedures are carried
out.
For dust extraction, please contact your
local sales.
The tool is designed for a working
pressure of 6.3 bar (90 psig). The
compressed air must be clean. The
performance, comply with the
compressed air connection).
A: Ømini = 10mm (3/8")
B: 7 m max.
A
1
09/2011
DECLARATION OF NOISE AND
VIBRATION EMISSION
(See page
All values are current as of the date of this
publication. For the latest information please visit
cp.com.
These declared values were obtained by
laboratory type testing in accordance with the
stated standards and are suitable for comparison
with the declared values of other tools tested
in accordance with the same standards. These
declared values are not adequate for use in risk
assessments and values measured in individual
work places may be higher. The actual exposure
values and risk of harm experienced by an
individual user are unique and depend upon
the way the user works, the workpiece and the
workstation design, as well upon the exposure
time and the physical condition of the user.
We, Chicago Pneumatic, cannot be held liable
B
for the consequences of using the declared
exposure, in an individual risk assessment in
2
The use of spare parts other than those
originally supplied by the manufacturer
may result in a drop in performance or
in increased maintenance and level of
vibration and in the full cancellation of
the manufacturer's liability.
pneumatic tool, preserve its features
and avoid repeated repairs, a routine
inspection and repair programme
are recommended at least every 500
hours, the intervals between the various
inspections depending on the amount of
exertion on the power tool.
Check the free speed of the tool
at regular intervals and after each
operation or maintenance task. Remove
the abrasive to check the speed. The
maximum allowed speed shown on
the tool must not be exceeded and the
vibration level must not be excessive.
operate without lubricated air. However,
a small amount of oil allows the tool to
provide full power and lengthens its life.
The use of dry air with no trace of oil
may reduce the life of blades.
33
)
3
6159949830
Issue n° 01
Series C
4
3 / 33