Running In The Tool - DeWalt DCN692 Originalanweisungen

ENGLISH
• For longer nails and more rigorous applications,
select speed 2 by setting the switch to the right
most position.
In the event that nails are not driving to depth in
speed setting 1, you may have to switch to speed
setting 2 for additional driving power.
NOTICE: Firing nails under 71 mm in
length using speed setting 2 will cause
excessive wear to your tool and may
result in early failures.
Speed
Benefit
Setting
Power to drive
2
longer nails
Increased
tool durability,
Increased
1 battery life,
Increased speed
of firing, Less
recoil
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
There may be local workplace
regulations applicable which interdict the
use of the bump action mode for certain
applications.
WARNING: To reduce the risk of
serious personal injury, turn tool
off and disconnect battery pack
before making any adjustments or
removing/installing attachments or
accessories. An accidental start-up
can cause injury.
Proper Hand Position (fi g. 7)
WARNING: To reduce the risk of
serious personal injury, ALWAYS use
proper hand position as shown.
WARNING: To reduce the risk of
serious personal injury, ALWAYS hold
securely in anticipation of a sudden
reaction.
58
Proper hand position requires one hand on the main
handle (r) as shown.
Preparing the Tool (fi g. 1)
1. Remove the battery pack (l) from the tool and
2. Remove all nails from the magazine (g).
3. Check if the contact trip (c) can move freely.
4. Reload the nails to the magazine.
5. Insert battery pack.
Typical
Application Nail
Length
Stud Work
Noggings
71 –
Joists
90 mm
Timber
framing
Flooring
Cladding

Running in the Tool

50 –
Fencing
Please note that this tool requires a run-in period
70 mm
before it operates with full power due to parts which
Boarding
need to mesh or wear in together. It may be that
Battening
the tool does not drive long nails flush consistently
during this period.
After driving between 500 and 1000 nails the tool
should have run-in and perform at full capacity.
Actuating the Tool (fi g. 1)
The tool can be operated using one of two modes:
SEQUENTIAL ACTION MODE
The sequential action mode is used for intermittent
nailing when very careful and accurate placement is
desired. It also offers the maximum delivery of power
for driving the longest nails.
1. Using the mode selector switch (i), select the
2. Release the trigger safety lock-off (b).
3. Push the contact trip (c) against the work
4. Pull the trigger switch (a) to actuate the tool.
5. Release the trigger and raise the nailer from the
6. Repeat steps 3–5 to actuate the next nail.
ensure the tool is locked off.
WARNING: Do not use the tool if the
contact trip or nail pusher cannot move
freely.
NOTICE: NEVER spray
or in any other way apply
lubricants or cleaning
solvents inside the tool.
This can seriously affect
the life and performance
of the tool.
sequential action mode ( ) or (
surface.
work surface.
).