Replacing The Lamp; Installation; Closing The Door - Electrolux IK2240CR Benutzerinformation

Problem
dEMo appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
If the advice does not lead to
the desired result, contact the
nearest Authorised Service
Centre.

7.2 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.

8. INSTALLATION

8.1 Location
Refer to the assembly
instructions for the
installation.
To ensure best performance, install the
appliance well away from sources of heat
Possible cause
The appliance is in dem-
onstration mode.
The temperature regulator
is not set correctly.
The door is not closed
correctly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The door has been
opened often.
The ActionFreeze function
or Shopping function is
switched on.
There is no cold air circu-
lation in the appliance.

7.3 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
3. If necessary, replace the defective
such as radiators, boilers, direct sunlight
etc. Make sure that air can circulate freely
around the back of the cabinet.
8.2 Positioning
Install the appliance in a dry, well
ventilated indoors where the ambient
Solution
Keep the OK pressed for ap-
proximately 10 seconds until
a long sound is heard and
display shuts off for a short
time.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only if neces-
sary.
Refer to "ActionFreeze func-
tion" or "Shopping function".
Make sure that there is cold
air circulation in the appli-
ance.
assembly instructions.
door gaskets. Contact the Authorised
Service Centre.
ENGLISH 61