Switching On The Equipment; Operating Indicators - Kärcher WATERCLEAN 600 LP / MP Betriebsanleitung

WTC 600 LP / MP
If the metering container was com-
pletely empty, the metering pump (29)
may have possibly drawn in air. In this
case, bleed the air from the pump as
described in Section 3.2.3.
3.1.3

Switching On the Equipment

• Check if the pumps of the metering station,
sand and activated carbon filter are connected
to the respective power outlets (18 / 19) at the
switch box (8).
• Check if the operating mode switch (9) is in the
correct position "Automatic" or "Hand".
In the "Automatic" operating mode, the
i
system is controlled via an external float
switch in the drinking water tank.
In the "Hand" operating mode, the sys-
tem is switched on and off manually via
the main switch.
• Switch the main switch (20) to the "I" position;
the system starts the drinking water produc-
tion.
3.1.4

Operating Indicators

Display of the controls (3 / 4) of the sand and acti-
vated carbon filters:
• Display of the time
• LED line: Display of the weekday
Control of the RO system:
The following is alternately indicated on the
two-line display of the control panel (10) of the RO
system:
• Equipment/model No. and operating condition,
• Drinking water temperature and drinking water
conductance value,
• Operating hours (_ _ _ _ _h _ _min).
Version 06/05
Maintenance and Care
5