Specifications; Specific Safety Rules - Makita HP2070 Betriebsanleitung

ENGLISH
1 Lock button
2 Switch trigger
3 Speed adjusting dial
4 Higher
5 Lower
6 Lamp
7 Reversing switch
8 Arrow
9 Speed change knob

SPECIFICATIONS

Model
Speed
Concrete
Capacities
No load speed (min
Blows per minute
Overall length
Net weight
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Note: Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for hammer drilling and drilling in
brick, concrete and stone.
It is also suitable for drilling without impact in wood,
metal, ceramic and plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
Safety hints
For your own safety, please refer to the enclosed safety
instructions.

SPECIFIC SAFETY RULES

DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to hammer drill safety rules. If you use this power
tool unsafely or incorrectly, you can suffer serious
personal injury.
1. Wear ear protectors with impact drills. Exposure
to noise can cause hearing loss.
2. Use auxiliary handles supplied with the tool.
Loss of control can cause personal injury.
4
Explanation of general view
10 Action mode changing lever
11 Grip base
12 Side grip (auxiliary handle)
13 Teeth
14 Protrusions
15 Chuck key
16 Sleeve
17 Ring
18 Retaining ring
HP2070/HP2070F
High
20 mm
Steel 8 mm
Wood 25 mm
–1
) 0 – 2,900
0 – 58,000
Low
-----
16 mm
40 mm
0 – 1,200
0 – 24,000
364 mm
2.6 kg
3. Hold power tools by insulated gripping surfaces,
when performing an operation where the cutting
accessory may contact hidden wiring or its own
cord. Cutting accessory contacting a "live" wire may
make exposed metal parts of the power tool "live"
and could give the operator an electric shock.
4. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
5. Hold the tool firmly with both hands.
6. Keep hands away from rotating parts.
7. Do not leave the tool running. Operate the tool
only when hand-held.
8. Do not touch the bit or the workpiece immedi-
ately after operation; they may be extremely hot
and could burn your skin.
9. Some material contains chemicals which may be
toxic. Take caution to prevent dust inhalation
and skin contact. Follow material supplier safety
data.
SAVE THESE INSTRUCTIONS.
WARNING:
MISUSE or failure to follow the safety rules stated in
GEB003-2
this instruction manual may cause serious personal
injury.
19 Hexagonal nut
20 Wrench 19
21 Depth gauge
22 Blow-out bulb
23 Power-ON indicator lamp
(green)
24 Service indicator lamp (red)
25 Vent holes
HP2071/HP2071F
High
20 mm
8 mm 16 mm
25 mm 40 mm
0 – 2,900 0 – 1,200
0 – 58,000 0 – 24,000
362 mm
2.6 kg
Low
-----