DeWalt DW432 Bedienungsanleitung Seite 23

Do not use a dustbag or vacuum
extractor without proper spark protection
when sanding metal.
• Slide the dustbag (9) onto the adaptor (14) over
the edges (15).
• Pull the locking collar (16) up.
• Locate the rim (17) behind the edge (18).
• Align the lugs (19) with the recesses (20).
• Firmly push the adaptor (14) into the dust
extraction outlet (21) until it clicks in place.
• Push the locking collar down.
Dust extraction shut-off
The dust extraction system can be disabled by
activating the dust extraction shut-off valve. This will
prevent the dust being blown toward the operator.
• To close the valve, push the switch (4) forward.
• To open the valve, pull the switch backward.
While using the dustbag, always make
sure the dust extraction shut-off valve is
open.
Instructions for use
• Always observe the safety instructions
and applicable regulations.
• Make sure all materials to be sanded are well
secured.
• Apply only a gentle pressure to the workpiece.
Excessive pressure does not improve the sanding
effect, but only results in an increased load on
the machine and causes the abrasive to tear.
• Avoid overloading.
Do not sand magnesium!
Switching on and off (fig. A)
• Switching on: press the on/off switch (1).
• For continuous operation, also press the lock-on
button (2).
• Switching off: press the on/off switch again.
Sanding (fig. A)
• Start with the coarsest grit size.
• Move the tool in long, sweeping strokes.
• Check your work at short intervals.
• Always switch off the tool when work is finished
and before unplugging.
Emptying the dustbag (fig. D1 & D2)
For efficient dust extraction empty the dustbag when
it is about one third full.
• Pull the locking collar (16) up.
• Remove the dustbag (9) and the adaptor (14)
together.
• Squeeze the marked locations (22) to remove the
adaptor from the dustbag.
• Gently shake out the dustbag.
Consult your dealer for further information on the
appropriate accessories.
Maintenance
Your D WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
Keep the ventilation slots clear and regularly clean
the housing with a soft cloth.
Unwanted tools and the environment
Take your tool to an authorized D
agent where it will be disposed of in an
environmentally safe way.
E N G L I S H
WALT repair
E
23