Connecting A Vcr - Sony KZ-32TS1E Bedienungsanleitung

(SMARTLINK)

Connecting a VCR:

To connect a VCR, please refer to the section "Connecting the Aerial and VCR" on page 8 of this
instruction manual. We recommend you connect your VCR using a Scart lead. If you do not
have a Scart lead, tune in the VCR test signal to the TV programme number "0" by using the
"Manual Programme Preset" option. (for details of how to manually programme these presets,
see page 22, step A).
Refer to your VCR instruction manual to find out how to find the output channel of your VCR.
Connecting a VCR that supports Smartlink:
Smartlink is a direct link between the TV set and the VCR. For more information on
Smartlink, please refer to the instruction manual of your VCR.
If you use a VCR that supports Smartlink, please connect the VCR by using a Scart lead to
the Scart 3/
If you have connected a decoder to the Scart
connected to this Scart:
Select the "Manual Programme Preset" option in the "Set Up" menu and after entering in the
"Decoder*" option, select "On" (by using
signal.
* This option is only available depending on the country you have selected in the "Language/
Country" menu.
Connecting to external Audio Equipment:
Plug in your Hi-Fi equipment to the audio output sockets F if you wish to amplify the audio
output from TV. Next, using the menu system, select the "Features" menu and set "TV
Speakers" to "Off."
For a sub woofer
Plug in your sub woofer to the 5 W/G/W/G output jack I using a monaural audio cable.
R/D/D/D L/G/S/I R/D/D/D L/G/S/I
R/D/D/D L/G/S/I Y/G P C B P C R HD VD
B/ B/ R/ R/
B.
S
or
CTRL S
AC IN
(W/G/W/G)
3/
S
). Repeat this option for each scrambled
To avoid noisy
picture, do not
connect external
equipment to
connectors D and
E at the same time.
or through a VCR
Additional Information
GB
29