Sony KZ-32TS1E Bedienungsanleitung Seite 14

Colour
Colour cannot be adjusted for the RGB input.
Sharpness
NR (Noise
Reduction)
You cannot adjust NR (Noise Reduction) for equipment connected to the RGB
input.
Dynamic Pict
Colour Tone
Colour Correct
Colour Correct cannot be adjusted for the RGB input.
Gamma Correct
Reset
Each option cannot be adjusted when Mode is set to Live or Standard.
14
Menu System
Press / to decrease colour intensity.
Press / to increase colour intensity.
Press / to soften the picture.
Press / to sharpen the picture.
Off/Low/Mid/High
Select to reduce the noise level of all connected equipment. It is
most effective on the signal from the VHF/UHF jack.
On/Off
Select to enhance the picture contrast.
Cool/Normal/Warm/User1/User2/User3
Select to give bright colours a red tint (Setting is variable from Cool
to Warm).
Select User1, User2, or User3 to customise the Colour Tone by
adjusting Red Gain, Green Gain, and Blue Gain (tint), and store
them in memory.
Name Set: Select to name your personal settings. Press
/ to select the letter, then press OK. Finally press
/ /
screen and press OK to store.
• To correct the letter, select
back and press OK.
• For a blank, select
On/Off
Select to emphasise reds and blues.
High/Mid/Low
Select to adjust the balance between bright and dark areas of the
picture.
Cancel/OK
Select OK to reset the picture to the factory preset levels.
or to select the word "End" on the
on the screen to go
on the screen and press OK.
/ /